Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was wondering if anyone would be able to help me out and guide me in going around configuring a Local Radius Server on a Cisco 1210 AP with the latest code and with WLSE running the latest code (2.9) so that I can scan for rogue access points with ...
I have been exploring a couple of wireless access points at work and have seen a lot of bleed through simply because the site survey was not correctly done at least according to my judgement. We have all of the access points configured requiring at l...
I recently upgraded an AP 1200 Series (G-Radio) to XR2 but in the process of pushing the upgrade to the AP, the connection was reset to the AP as I was remotely upgrading it using TFTP Server.When I consoled into the AP, I found out the following:Xmo...
I recently upgraded one of the 1200 Series AP to the XR2 IOS. In the process of doing so, I lost the connection to the AP as I was doing the upgrade remotely.I consoled into the AP and it displays that "No Boot" and it shows it has the "Boot-M JA8" T...
Hi, It seems to me like you are running multiple VLANS. If so is that case, then you need to make sure the WLAN is being passed on the second floor.In this typical case, you usually have a management VLAN and a WLAN. The WLAN has to be passed through...
Hi, We have the same kind of network that you described. We are passing WLAN transparently over our Management VLAN. We are using a third party box that is a gateway and uses LDAP to authenticate all the users. If you have any questions, please feel ...
Hi rayflor, Thank you very much for your guidance. This acually helped me out a lot. I was able to restore the access point image and upgrade later on to the newest one out there.If anyone needs or comes across such a problem, please let me know I wi...
Hello, I had the same problem and it happened to me after I upgraded to XR2. I tried all the steps that you all discussed but was not successful to get anything accomplished. I havent had the time to do an RMA and that seems to be the only alternativ...
This was before when I was able to console to the AP. Now even if I do a hard reset - by removing the power from the AP and plugging it back in it doesnt load. It started doing this when I tried to reset it from the CLI and the Terminal Program hung ...
