Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I connected MDS9506 at 2.0.2b level with Brocade in BladeCenter at 4.2.1 level. VSAN on MDS is in interoperability 3 and the only change on Brocade was "portcfgislmode 0/0 1". Then zones, zonesets, IVR info, everything was propagated to Brocade an...
Hi, I just started to work with device-alias and have a question - how do I change a device alias. All I found was "no deviace-alias name..." and then again "device-alias name...". Then commit of course.BUT, pwwns in zones (which were defined using d...
switch(config)# switchname A_AInvalid switchname. Must start with a letter, end with alphanumericand contain alphanumeric and hyphen onlyswitch(config)# switchname A-AA-A(config)#is it a bug or "_" became unsupported ? It is 2.0.2b firmware on 9506I ...
HI, I will have three MDS switches connected together in triangle, using portchannel (2-4 links in portchannel) to connect them. There will be 3 or 4 VSANs. I have to connect Brocade switch to one of them and allow servers connected to Brocade to acc...
I read config guide but don't get clear answer - if I have one VSAN with FICON enabled, one VSAN for storage-server FC traffic and one VSAN for PPRC between IBM ESS 800s and I have portchannel consisting from several links, can I share this portchann...
Two HBAs I had three HBAs swapped in triangle and six other wrong HBAs.I cannot find any command to do it, I think it is possible with fcalias, but I had to use device alias as IVR doesn't support fcaliases.BTW I haven't found device alias definiti...
I looked at this document and have another question. There is a section specificaly talking about connecting to IBM Bladecenter which is my case. It is stated there, interoperability mode is not needed, but they talk about QLogic switch inside Bladec...
I looked at this document and have another question. There is a section specificaly talking about connecting to IBM Bladecenter which is my case. It is stated there, interoperability mode is not needed, but they talk about QLogic switch inside Bladec...
