03-31-2005 11:29 PM
switch(config)# switchname A_A
Invalid switchname. Must start with a letter, end with alphanumeric
and contain alphanumeric and hyphen only
switch(config)# switchname A-A
A-A(config)#
is it a bug or "_" became unsupported ? It is 2.0.2b firmware on 9506
I used "_" under 1.3.5
Solved! Go to Solution.
04-01-2005 05:55 AM
This is a clip from interal mail I saw last week here in Cisco.
In the previous releases we where allowing almost anything as hostname. This caused trouble with some 3rd-party applications.
Now we are following RFC 1035 section 2.3.1
The labels must follow the rules for ARPANET host names. They must start with a letter, end with a letter or digit, and have as interior characters only letters, digits, and hyphen. There are also some
restrictions on the length. Labels must be 63 characters or less.
The check is disabled with scripting to be compatible with older releases, but enforced by CLI/SNMP.
04-01-2005 05:55 AM
This is a clip from interal mail I saw last week here in Cisco.
In the previous releases we where allowing almost anything as hostname. This caused trouble with some 3rd-party applications.
Now we are following RFC 1035 section 2.3.1
The labels must follow the rules for ARPANET host names. They must start with a letter, end with a letter or digit, and have as interior characters only letters, digits, and hyphen. There are also some
restrictions on the length. Labels must be 63 characters or less.
The check is disabled with scripting to be compatible with older releases, but enforced by CLI/SNMP.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide