Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've started the Modeling lab a few times now and it doesnt seem to spin up the network elements, only the dev and management boxes.Any ideas? what am I doing wrong?
This morning one of our office complained about the wireless no longer being available.Upon checking the our Cisco 2106 WLC i noticed that while the APs were up (admin state) the radios were down. The log showed this:*apfReceiveTask: Aug 12 19:15:20....
What is the best way to impliment QOS over VPN links for IP Phone to CCM communications? ais there anyway to mark traffic before the VPN tunnel? anyway to mark it for or in the VPN tunnel?
Thank you RicIt would have been too easy the channels 1/6/11 are already enabled. And this has been working for a while with intermittent issues.yesterday it stopped, and the log message is what shows up.
