Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an existing site to site VPN through a PIX 515E software ver. 7.0(2) for remote network 172.18.x.x. I need to add a new remote network 10.126.x.x to the remote site and have the local users access the new network across the same VPN. How do I ...
Currently I have an internal 2621 router set as the default gateway for the network. I have a PIX515E with the internet connection directly connected to it. What I want to do is limit the bandwidth going across the internet connection to 2 megs max. ...
Our site uses an ISP that offers burst rate service. So I want to limit what the max bandwidth will burst to. We have found that if the traffic exceeds the 2 meg burst at a sustained rate we start having slow downs and a chain of collapsing connectio...
Thank you for the responses. Will either of these configurations work if the router does not have a direct connection to the PIX? Currently they both share the same network segment, but don't have an interface to interface connection to each other.
Thanks for the initial response. Do you have any suggestions for the following setup. I have an internal 2621 router with a WAN connection and a PIX 515E which also has a WAN connection. What I want to do is use the internal router as the default gat...
