I have my APs (350 & 1200) on Cisco 2950 switches. For the optimal setup, should I have the AP set at 100/Full Duplex? Should I set the port on the switch to 100/Full? Should I have spanning tree 'portfast' set on the port on the switch? Thanks,

Please advise me on this. I have four 1200 Access Points with the latest firmware. They are on the same subnet. When I am associated with an AP the signal strength is Excellent. As I move far away from the AP the signal decreases to Fair. I am clos...

I have several Novell 5 & 6 servers running pure IP. All of my Desktops run fine with a wired NIC. All of my XP wireless laptops run fine with either a CISCO 350 wireless card or its own internal NIC. The problem I have is with 2 models of laptops....