Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm working on a project to replace an old Nortel router with a Cisco 2600. The problem is the redundant PVCs. I have one physical frame relay circuit with two sub interfaces. One of the sub-interfaces is weighted to be the primary interface. What...
Has anyone hads issues installing Gig modules in their 535? I had recently tried to upgrade two ports(slots 0&1)from 100mb to Gig and ran into mutiple problems. First, any change that I made in the PIX or the connected switch would cause me to lose...
That's funny you mention it. Just minutes before I came back to check on this post, I had tried changing to EIGRP. Huge improvement. I'm just going to can the RIP and stick with EIGRP. Thank you for your response though.
