Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I installed cXR-6.5.3 on an ASR9006 with dual RSP880 and one A9K-48X10GE-1G-SE. After running through the FDP upgrade procedure I noticed that three FPDs (fpga2, fsbl, lnxfw) on the RSPs failed to upgrade. (or maybe they did but reporting in the ...
HI, I recently installed CSM 3.5, and enabled 2 ASR9ks as hosts. Unfortunately, CSM cannont sucessfully retrieve the inventory.
It ends with this Error:
InvalidRequestError: This Session's transaction has been rolled back due to a previous exceptio...
HI,
I do have a problem on and ASR920. I configured two service instances on one physical interface for different .1q VLANs. Both instances attach the same device into the same bridge-domain. This is intended to be used for two euqal services fro...
HI,
I am testing a VPLS Inter-AS Option-B Setup for both, BGP and LDP signaling VPLS-VPNs.
This is working between IOS-XE machines, but IOS-XR seems to lack the support for this.
For LDP, ASR9k does not build any segmented PWs and for BGP there are n...
Hi,
I am currently testing seamless MPLS, and tried to start LDP-DoD from an ASR920
which acts as an AccesNode towards a DSLAM. It seems as the ASR 920 with IOS-XE.
I tried 03.18.02.S and 03.18.01.SP, and also CCO does not mention any support of LD...
Hi xander,
Thanks for you aswere and sorry for my loose explanation. I am looking into VPLS Option B on IOS-XR in the same manner as it is supported on IOS for Signalling types (BGP and LDP).
Thanks, Rene
HI,
I attached the specific config of the IOS-XR ASBR. This is taken form a VIRL simulation. I understand that XR cannot do VPLS at the edge in VIRL. However, I dont see any reason why XR should not be able to do the ASBR job as this only involves l...
