Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We got a MARS 25r with 2 5510 failover, i think i got logging setup as in the dashboard of the mars i see logs from the firewall persay but not truelogs? we were under the impression that mars would serve as a place we could archive firewall logs for...
ok i got the ASA up and running and our license PAK came in and it says to go to http://cisco.com/go/license which i do run through like the wizard, at the end i get thisWrong Sku(s) 'ASA5510-SEC-PL=' for 'ASA5510-AIP10-K9'Serial Number = xxxxxxxxxx...
OK im new and will be asking lots of questions, im a checkpoint guy but we are switching to cisc ASA so going to take me a min to get used to.... but we have a brand new out of box 5510, which has 5 interfaces plus the management interface so 6 tot...
OK im new to ASA im officially going to training in 4 weeks but would like to get familiar with the unit, we got 2 x 5510 and mars. Now im read everything i think about getting the ASDM up, like go to https://192.168.1.1 well i attempt but i get no ...
OK im at 8.0(4) and still only show eth0/0 - eth0/3 and the management port, the other port isn't showing up?? we did get the IPS is that the IPS port?
ok well the issue was i was putting in two paks cause it sorta ask for all you have. But i tried just one with one s/n and it worked thanks. But all interfaces show except for one and im wondering if its the IPS module, as im not familiar. But if you...
ohh you knwo im sure we got the active/passive stuff but like i said first time im done ASA if i purchase a device are the license online or they already installed?
