02-18-2009 06:03 AM - edited 03-10-2019 04:30 AM
I have never configured AIP-SSM and looking for a how to guide that is short and to the point... any one got one??
02-19-2009 08:07 PM
1) login to the ASA and type
#session 1
2) on the IPS prompt type
#setup
3) then fill up the setting based on the questions, and configure the management IP address.
4) configur your PC or LAPTOP with IP address from the same subnets and connect through the GUI interface and then use the Wizard for configuring the sensor.
enjoy
02-20-2009 09:37 AM
step 3 1/2 - connect a cable to the management port of the AIP-SSM, this is how you'll be accessing the unit via ssh and https.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide