About Worker247

Worker247 · 07-30-2020

Hi,I get lots of EXCESSIVE_PARITY_ERROR - Messages on a 6880X running in a VSS.Example:Jul 29 13:04:56 10.15.1.239 361325: Jul 29 07:48:22.849: %EARL-SW2_DFC1-1-EXCESSIVE_PARITY_ERROR: EARL 0: Parity error detected in VRAMJul 29 13:04:58 10.15.1.239 ...

Worker247 · 08-03-2020

To date all is ok.Thanks for the answers.all bestCa

Worker247 · 08-02-2020

Hi Leo Laohoo,I reseatet the Linecard as you proposed but somehow the linecard was not detected by the Chassis.All port-LEDs of the linecard did not Flash at all so first i thaught I had to power the linecard up. So I typed:(config)#power enable swit...

Worker247 · 07-30-2020

Thanks for the info.I reseat the card on sunday and report afterwards.all bestCa

Worker247 · 07-30-2020

... good to know. I will try to reseat the linecard as you proposed.As the error Messages state "SW2_DFC1-1" for the parity errorsdo I have to reseat the linecard in Switch2, Slot 1? Hints "EARL-SW2_DFC1-3-NF_PARITY_ERROR: EARL 0 NF ASIC: Uncorrecta...

Member Since	‎04-05-2018 02:11 AM
Date Last Visited	‎08-20-2025 07:10 PM
Posts	5

User Statistics

User Activity

Catalyst 6880 - EXCESSIVE_PARITY_ERROR - how to reload a single linecard

Re: Catalyst 6880 - EXCESSIVE_PARITY_ERROR - how to reload a single linecard

Re: Catalyst 6880 - EXCESSIVE_PARITY_ERROR - how to reload a single linecard

Re: Catalyst 6880 - EXCESSIVE_PARITY_ERROR - how to reload a single linecard

Re: Catalyst 6880 - EXCESSIVE_PARITY_ERROR - how to reload a single linecard