Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I don't know where exactly to start from. So instead, i will jump right on to the question.Say you are being provided with 2 IP addresses, PC 1's IP address and PC 2's IP address, which are 17.4.4.2 and 14.2.3.2 respectively. You are required to fin...
<p>Can anyone please confirm it to me that it is right to say that, when calculating a subnet mask, the point where we borrow bits from the host portion in order to form new subnets we use the formula <strong>2 to the power of n - 2 </strong>for clas...
I am trying to work on the Cisco Packet tracer 5.0 for some time now.. But everytime i configure an interface and then verify it show the "show" command. I am getting an information displayed that says the port is disabled .. Can anyone please provid...
I am pretty confident of how to do the subnetting of any paticular class but what i am doubtful about is the concept, when you chose certain number of bits from the host portion in order to be used as subnet bits. Do we use the formula [b]2 to the po...
Can anyone please provide me with the information of how to change the BAUD rate.. As i just upgraded my IOS, 2950 switch, and in order to do that i had to increase my BAUD rate from the default 9600 to 115200 bps.. Now whenever i try to access my sw...
In fact John you are the only person who has got it right till yet.. I wanted to know is there any way, or is there any hard and fast rule that can be applied to this kind of problem.I really need to know if there is any way, using the decimal number...
I am sorry but my question is a total hypothetical one.. I just wanted to know is there a way in which we can find out the prefix mask theoretically.. Please let me know in case you are ware of any method apart from the binary one..
If you remember i have this problem since a long time.. What i want to do , basically is just copy a new image file for the IOS of the switch as my previous one is corrupted or is missing.. Now whenever i try to download the image file using xmodem i...
right now i am sitting right in front of that switch and trying to install a new IOS image on the switch but every time i try to do that after probably 30 secs or so i get this error messages, in order to view the error message please view the attach...
