Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiHaving some issues retrieving the full set of information from certain devices in User Tracking Reports (these devices at a remote site). I am only recieving the MAC address, devicename, ports and last seen info (missing subnet, IP address, hostnam...
Hi guysI've tried without success to stop the daily inventory collection of all nodes within LMS 2.6.I have my RME inventory collection set to monthly and polling set to weekly (under Admin > Inventory > System Job Schedule > ).I've tried stopping th...
Hi thereIt seems that when deploying a private config file from a field device to a local hot-standby device using RCP as a deploument method, the configuration is deploying OK, but it is not saving. I was wondering if this was normal?Steps we are ta...
Hi thereI'm unable to do a config backup for two devices in our network that are both Catalyst 6509 switches. There are 6 other devices of the same model that work OK.- LMS 2.6 using ACS integration (ACS 3.3)I have;- checked device packages and made ...
In LMS 2.6 you can't do a bulk import in common services from a HPOV NNM server if that server is running on windows. (I've tried installing some unix rsh tools without success)Does LMS 3.0 support this?I would like to import into CW running windows ...
I just had the same problem with a pair of new Cisco 1113's. The solution is to do a re-image of the server with the supplied restore disc. (Not great, but it works)There is a TAC case example here (http://www.ciscotaccc.com/security/showcase?case=K5...
Hi JoeI ran a sniffer and found that the switch was gettting into enable mode, then dropping out for some reason.I then loaded the device into our DEV instance of RME and was able to successfully manage this device. It took me a while to work out wha...
Worked thanks again Joe.The last iteration of that job (1001.340) was still there though. I was able to stop it, but it stays there as "Stop Initiated".Even after stopping and restarting services I am unable to delete it ("Could not delete following ...
I'm getting the same issue. When I search online I find the update, but the same CCO ID within CiscoWorks returns with no results. Perhaps the URL where the patches are located has changed and CiscoWorks can't find them?
Thanks Joe. I will have to use a sniffer as those commands are coming through in the ACS logs for devices that are successful, but nothing is showing up for the unsuccessful devices in "Tacacs+ Administration active".For others reading this post, I a...
