If you must use a tech-prefix for each site, then you must enter the CCM address explicitly.gw-type-prefix 1#* gw ipaddr {address of CCM}Hope this helps.
Normally gw-type-prefix strings are used for gateways of different technologies instead of different sites. If you only have one CM cluster, then the default-technology option would route all unknown addresses to the CCM, since oyu have the prefix in...
OK. Just happened to look at your debugs. It seems your CCM is registered. If your 1# prefix is strictly for CCM, try adding the default-technology option after your gw-type-prefix 1#* statement.
do a 'sho gatekeeper endpoint' on the agteleeper to see if the ccm is registered. CCM does not register the e.164 ids to gatekeepers, so you must use the gw-type-prefix command to route the calls. Hope this helps.
