I'm trying to turn off the LED on a Cisco Aironet 1141 p/n AIR-AP1141N-A-K9. This is a standalone AP and from the CLI I'm issuing this command: ap(config)#led display off The LED does not turn off after typing this command. If I do `show run' it shows up in the config so the command was accepted. Is there a different way to turn off the LED? I'm running IOS Version 12.4(21a)JA1.
... View more
I have a SR520 router which has a ADSL connection and I'm wondering if it is possible to configure the router so that a port can be forwarded to a Linux server that is on the same LAN network as the VLAN on the router without having a route/gateway setup on the Linux server. If I set the router vlan IP address as the gateway on the Linux box then it works as expected and I can connect from a public IP to the local IP of the Linux server, but if I remove the gateway on the Linux computer, I can no longer connect, but since the LInux computer is on the same local network as the router it seems like it should be possible. Below is the router config, I would like to be able to ftp from a public IP to 192.168.1.5 which is the local Linux box. I know there can't be any outbound traffic from the Linux box without the gateway being set, but this is ok, or are routes a two way street and what I want can't be done? One thought I had was to use the remote command feature of ssh: ssh <router-public-ip> 'ftp 192.168.1.5' The problem with this is the router doesn't have a ftp command to connect to a ftp server. version 12.4 no service pad service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname SR520 ! boot-start-marker boot-end-marker ! logging message-counter syslog enable secret 5 ! no aaa new-model ! dot11 syslog ip source-route ! ! ! ip cef ! no ipv6 cef multilink bundle-name authenticated ! ! username cisco privilege 15 secret 5 ! ! ! archive log config hidekeys ! ! ! bridge irb ! ! interface ATM0 no ip address no atm ilmi-keepalive pvc 0/35 encapsulation aal5snap ! dsl operating-mode auto bridge-group 1 ! interface FastEthernet0 switchport access vlan 75 ! interface FastEthernet1 switchport access vlan 75 ! interface FastEthernet2 switchport access vlan 75 ! interface FastEthernet3 switchport access vlan 75 ! interface Vlan1 no ip address shutdown ! interface Vlan75 ip address 192.168.1.1 255.255.255.0 ip nat inside ip virtual-reassembly ! interface BVI1 ip address dhcp ip nat outside ip virtual-reassembly ! ip forward-protocol nd ip route 0.0.0.0 0.0.0.0 atm0 ! no ip http server no ip http secure-server ip nat inside source list 100 interface BVI1 overload ip nat inside source static tcp 192.168.1.5 21 interface BVI1 21 ! access-list 100 permit ip any any ! ! control-plane ! bridge 1 protocol ieee bridge 1 route ip !
... View more