Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, experts.After applying in the FTD a rule to block the Teamviewer application for the internal hosts to internet (INSIDE to OUTSIDE),I found in LINA this: FTD-5516X-XXX# show access-list CSM_FW_ACL_ | i 268434489access-list CSM_FW_ACL_ line 219 re...
Hi all,
Any idea of the new tool to migrate from ASA to FTD announced by Cisco to be released on mid-May-2018 and later moved to mid-June-2018. A Cisco´s employed told me that it was already released but I can´t find it yet. Thank you very much in ...
Hi,After 2 or 3 days that I upgrade IOS to the version shown below and configured the aaa services, I am unable to enter to the switches via SSH. Only after reinit the switches, I am able to enter via SSH.Any idea about this issue ? Switch Ports Mod...
Hey Networkers, there are some other flags. I found the list now in the FTD. Hope helps. FTD-XXX# show conn detail2124 in use, 40222 most usedInspect Snort:preserve-connection: 2111 enabled, 8 in effect, 40202 most enabled, 188 most in effectFlags: A...
The default action is se to block all. See image. A default action set to other must add: permit ip any any (without zones).Note the rule blocking the Application (Teamviewer in this case) is adding the permit action.As a workaround I am looking to d...
Leo, you are right. I review the switches personally on site, and the message on the console is: "%% Low on memory; try again later". I will try a lower IOS version that use less resources.I'm very grateful with your help. regards.
