Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm stuck on the requirement to have an intermediate certificate for decryption. I have a certificate assigned to the ASA from a commercial CA for SSL VPN purposes; could I use that? Concerning the private key, is that what's contained in the initial...
I have a particular application that needs to communicate with a server on port 10367 over the internet. The host that this application is on is behind our firewall being PAT'ed to a public IP. The problem is, the server it contacts apparently wants ...
Does anyone see anything wrong with this config. ? I just recently had to switch ISP and got only one IP from my new one. Since then, internet access has been sporadic at best and I cant seem to figure it out. Simple config for the most part other th...
Could someone please explain the difference between the two. We can currenlty get SDSL service but dont want a separate DSL Modem. Could the WIC-1SHDSL be used? Any replies are appreciated.JR
Does anyone see any problem with the following config. of two 56k CSU/DSU's? Notice the high input errors on one interface. Telco. says line seems to be fine and loopback test turns out ok. I just cleared the counters but they went back up in a matte...
Seems to be a known issue going from 6.0.0.1 to 6.0.1. I encountered the same error and found the following solution from another board just before calling TAC.
"PSA: don't upgrade to 6.0.1 if you're using custom object groups in your variables. You...
I'm not so sure this isn't a bug. I'm experiencing this on a 506 with the same version. Our clients query an internal caching only server that resolves requests for them. Works fine for a few hours then it won't pass any more queries, doesnt even sho...
I would rather tell you why my lines are different by looking at your config. Post it without passwords and last two octets of public ip's. Your lines look correct but if you are doing port redirection based on the outside interface, then you need to...
