Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I noticed some strange behavior yesterday on our 5520 controllers running version 8.5.135 and was wondering if this was 'working as designed' or rather a bug.While troubleshooting a coverage issue, I noticed a lot of our APs were using a chann...
I already have quite some experience with Aruba wireless controllers. However at my new job they purchased Cisco controllers so I am now trying to master the Cisco wireless side as well. However I'm still missing several features/information and I wa...
Hardware: Cisco Nexus 5548 + 4x Nexus 2248 FEX Software: 7.0(8)N1(1)
While troubleshooting some network issues, I noticed several interfaces listed jumbo frames on our Nexus 5K. Even after clearing the counters, they were still increasing in quite la...
Thank you for that link, that was a very interesting read!However, if I understand correctly from below link, you have to select the 'best' option to enable DBS. This means that in our environment, DBS should not be enabled as most of our global sett...
Do you perhaps have some documentation on this because I find that bit difficult to believe?If I configure 40Mhz in the global 802.11a settings and also in the RF-profiles attached to those APs, you're saying they still might fall back to 20Mhz? Also...
Hi Sandeep, thanks for the quick reply.
Show wlan apgroups only shows the AP groups and the configured SSID's. Isn't there a command to show what an AP is actually broadcasting? If you disable a wlan, it will still show under those commands (= conf...
