Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 2 Rath 2100-986 VoIP emergency endpoints. Under the hood this is a Digital Acoustics SS8 IP7-FD-BRD is a board-level full-duplex IP Intercom.We use these as emergency phones, with a single button to call 911.They have both been rock solid, bu...
We're looking at getting a number of 8811 phones.How do I tell if they are compatible with CUCM System version: 11.0.1.21900-10? In the docs I see:Table 5. Cisco Unified IP Phone 8800 Series Device TypeDevice Release Unified CM 12.0(1)Unified CM 11.5...
Hi,
I am pretty new to ASA's, and I've been given this task to do. I've set up NAT a few times on ASDM, which seemed quite straightforward: 1) create network objects, 2) config NAT on the internal network object, 3) create an ACL to allow traffic thr...
And I see this:Configure the end user that will be the Digest User. Note If the third-party phone that is running SIP does not support an authorization ID (digest user), create a user with a user ID that matches the DN of the third-party phone. For...
There's no digest user for the working phone, and the phone that used to work also had no digest user. I have also read that you need a digest user. But I have a phone working without one!
The only way I know how to run packet tracer is on ASDM - here is what I see at the end.
Is this the part of running-config you need to see? (I have changed from udp/443 to ip to test if that was the issue).
nat (inside,merit) source static any any...
