Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day, I have a wireless phone 7921, trying to connect it to an autonomous AP 1131. I tried configuring both WPA and WPA with TKIP and AES, and it does not associate, it is not even showing as an authentication failed, it seems that it is not even...
Hello,
I have a customer that requires to have 1 gig of throughput for the wireless connection.
Assuming I have everything needed from the wireless side (client supporting 802.11ac wave, the proper AP), how should the wired network should be conf...
Hi all,
Is it possible to configure an AP 3700 as a repeater?
I have configured one 3700 as the Access Point and I want to add another 3700 as a repeater (due to some infrastructure issues is not possible to run a cable). When I powered on the se...
Good afternoon,
I have an outdoor AP 1572 connected to an AIR-ANT2513P4M-N= antenna. The access point is powered using POE that connects to a SB SG300 switch.
I configured the Access Point to autonomous, with Version 15.3(3)JC.
The problem is that ...
I have an antenna AIR-ANT2513P4M-N and I have to connect it to AP 1572EAC outdoor.
When I tried to make the connection with the cable AIR-CAB005LL-R-N I, I wasnt able because the cable is male and female and the AP & antenna has all their N connecto...
Thanks for your response Rasika, Attached you can find the sh run. The firmware version of the phone is 1.4.6. Just as an additional note, we have other sites with the exact same configuration and it is currently working. Thank you for your help!
Hi Leo,Yes, he does (at least that's what I have been assured)I was concerned about the design of the wired network, however you just clarified it.Which AP would you recommend to this scenario?Thank you for your help.
Hi Rasika,Thanks for your answer.I understand it. However, my question is focused more on the design. How would my wired network should be designed, in order to obtain 1 Gig of throughput at least for that single client?
