Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I was attemping to summarize to default the other day, and it raised some questions for me regarding EIGRP.
I applied summarization to default on the agg routers as shown in the diagram. AD is set to 254 so that the default will not clobber ...
Looking at this a little bit closer, I see that the answer is pretty simple. AD takes precedence over metric even within the protocol. Summary routes are not a special case, it applies to any routes. I erroneously thought that within the routing ...
Additional information from TAC:
There are some side effects with creating a summary default route when there is also a learned default route. It is not common practice to summarize a route that exists in the same protocol.
This is not Design bes...
R1#show debugLoad for five secs: 1%/100%; one minute: 1%; five minutes: 1%Time source is hardware calendar, *17:20:19.615 UTC Wed Jul 20 2016
IP routing: IP routing debugging is onEIGRP: Finite State Machine debugging is on
R1(config)#int g2/0R1(con...
Here is a more direct statement of the question. R1 and R2 are each generating summaries to one another. I was considering that perhaps EIGRP takes all feasible successor routes and presents them to the RIB, where there AD could be considered. ...
