Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,
I have been trying to Setup a New Network for the past few days but i have encountered serious issues with the Interfaces communication. My Software version is Cisco Adaptive Security Appliance Software Version 9.5(2) with Security De...
Hi Everyone,
i just purchased my Cisco Router 871 K9 Version running this System image flash:c870-advsecurityk9-mz.124-4.T8.bin"
I am trying to configure this Router for Home use so that i can block some Web traffic (Porn sites, Movie sites because ...
Hello Yugant,
Thank you for your response. I appreciate it. You were absolutely correct. I was able to solve the problem after searching out your discussion where i got another user having my problem. The issue was resolved issuing the following comm...
Hi Michael,
I could not configure Vlan directly on the interface and when i did configure the Vlan on the sub-interface, the sub-interface did not communicate with each other.
I don't know what else to try.
Thanks
Hi Michael,
I appreciate your prompt response. However, the model is ASA 5516X and comes with Gigabit Interface Ports. Vlans are not configurable on the interfaces except i tag the Traffic on the Ports with the Encapsulation dot1Q as the Vlan config...
Hi,
Please can i use Linksys SPA3102 as the PSTN gateway for SPA9000?
I am setting up SPA9000 but have only PSTN as the only gateway Option. SPA400 seems too expensive for me. I am thinking if i can use SPA3102 as an alternative.
Your confirmation...
Hi Masoud / Milos,
One last thing please. So sorry to bother you on the same topic again.
The Computers on the LAN are unable to communicate. I am unable to reach the clients connected to fa0-fa3 from the Console, neither can the clients communicate ...
