Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings All,
I wanted to ask for guidance in configuring a cross-stack etherchannel between an isr 4451-X via 1Gbps Fiber to 4 3850 switches in stackwise configuration.
I would prefer not to assign an IP address to my port channel.
Here's wh...
I have had the same issue, and I can tell you how to set the BAUD rate on picocom in order to access the SM-X module inside your 4K ISR. Launch picocom like normal.hw-module session 1/0If you press CTRL A, then press H; this will show you the list of...
I have also tried this as just etherchannel on, rather than LACP with the same results.
The 3850's are supposed to add support for PAgP and LACP.
As soon as you turn on the ports (or connect the ports) the BDI interfaces on the router come up.
...
