About rizzast

rizzast · 10-31-2010

i found this statement in a file but did not explain it any further.These neighbour/peer relationships only occur over primary interface addresses NOT via any secondary addresses that may be configured!does that include subinterfaces? only the primar...

rizzast · 12-12-2011

hope you do not mind jumping on this old discussion!i am having the same error.you re-installed and made calls from Outlook? you were able to login to CUPC.

rizzast · 11-01-2010

again thanks for your help,I'm going to change my setup to what ever works. so I'm setting up frame relay.As far as what-why i got into this. I am running OSPF on network 172.16.0.0 and EIGRP on 10.0.0.0. I was keeping the two networks seperate until...

rizzast · 11-01-2010

thanks Rick for your help,i am convinced that DHCP doesn't support subinterfaces. that's why adjacency is not forming. so, i should go to frame relay encapsulation.you are right traceroute the ip on the primary interface is answering.RTR-1(2511)#sh c...

rizzast · 11-01-2010

yes, i have different parts of the network with OSPF and others with EIGRP.since i do not have other interfaces on the 2500. i would use one subinterface S0.1 for OSPF in the 172.16.0.0. network and S0.2 for EIGRP in the 10.0.0.0 network.yes, the int...

rizzast · 11-01-2010

thanks Peter for the reply.Obviously my subinterfaces are not establishing adjacencies in EIGRP nor OSPF.i tried it with two sets of different routers. tried removing ip address from the primary interface.the subnet is in the routing table, it shows ...

Member Since	‎06-02-2005 11:13 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	9

User Statistics

User Activity

EIGRP

CUPC cannot login

Re: EIGRP

Re: EIGRP

Re: EIGRP

Re: EIGRP