Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have Wireless Control System Version 4.2.62.0 installed and are currently converting existing 1220 and 1231 aps to LWAPP. I have added all the Autonomous AP's in WCS and placed them on maps. All my Autonomous AP's are running at 100% power yet whe...
I seem to remember that WDS running on a single AP could handle authenication for up to 100 AP's. I also read where there can only be one AP running WDS on a given broadcast domain. All of my AP's, close to 150, are on one VLAN or broadcast domain. A...
"Go to Configure -> Access Points-> Go to specific Radio say 802.11 b/g . On that you have the option to customize the power levels."That option is not available to Autonomous AP's.
My controllers are set to Accept Self Signed Certificates and it appears that the .csv file has a HASH key in it also. But still I'm getting the same errors as the above poster bmullen is getting on several of my converted 1220 and 1231 APs.
My controllers are set to Accept Self Signed Certificates and it appears that the .csv file has a HASH key in it also. But still I'm getting the same errors as the above poster bmullen is getting on several of my converted 1220 and 1231 APs.
