Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Informational message in cisco AnyConnect when connecting to a specific tunnel-group
Hi all!Help please solve the problem.In our organization, to subdue VPN clients, we use several different tunnel groups with different URLs.We need to make an inform...
Hi, please help me to understand and find the reason.Can't do a backup at all. CSM backup failed error appears in the GUI. After I checked the logs in /var/log/backup.log there are the following messages:
*********************************************...
Please help me solve the problem.We have Cisco UCS Manager together with fabric interconnect There are three IP addresses, one for Fabric Interconnect A (primary) (IP address of the web interface https://1.1.1.1/), one for Fabric Interconnect B (subo...
I have a switch 3560g that has cameras connected to the ports.Hikvision camera model.and ports are constantly changed state to down and up.How can I find out the reason?The cameras work correctly. 038509: Mar 4 09:57:45.256 ALMT: %LINEPROTO-5-UPDOWN...
Hi all.I have exactly the same problem, only after deleting the message, the deployment in the GUI continues, but when I re-check for the presence of the message, it is missing.
Tried to reboot both FMC and FTD. Nothing helps.
Good afternoonPlease tell me, if I add a banner in the group policy, can I insert a link to some resource here, for example
conf tgroup-policy %PolicyName% attributesbanner login “https://mycompany.com/knowledgebase/usermanuals/docs/”
Will it work as...
Yes thank you!I know about settings of a banner in politicians. I pointed this out in the test of my main problem.
The fact is that we have several different URLs that are used by different groups of people, such as for example different companies. E...
Oh yes, I found it, it is located in the main ASA configuration.It appears when I ssh into the ASA itself, but this is not what I need)I want to have a message appear in AnyConnectAs in the screenshot. This picture is just taken from the internet.
HelloI managed to enter this command.But after I pressed enter, I was thrown into configuration mode. and when checking show run, there is no banner there.
I tried to connect via anyConnect, but no message came up. I just successfully connected
ASA# ...
