Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Daniel,Please make sure you have reset the IPS after changing the RegexDepth setting in sensorApp.conf. Also, if the IDSM2 are inspecting traffic twice, please make sure that you have each vlan pair in a different virtual sensor. Or you can keep...
Hi Chris, Configuration on IPS is not synchronized between ASA failover pair. For IPS we have to manually copy the same configuration on both modules. Once you have configured the first IPS fully you can copy that to a tftp or a ftp server ...
Hi Daniel, Please check if you are at the latest sig level as there were a few sigs that were affecting the performance in file transfer scenarios. A show version on the IDSM2 would tell us the major version and also the Sig level. If...
Also make sure the signatures 2000 and 2004 are un retired besides enabling them. In recent versions they have been retired. qssp-8083(config-sig-sig)# statqssp-8083(config-sig-sig-sta)# sh set status ---------------------------------------------...
Hi, The IDSM2 is rated at 500 Mbps based on http traffic with average segment size of 650 bytes. Any other traffic profile with lesser packet size and non-TCP protocol can adversely impact the performance. However 50 Mbps sounds very low for any ...
