Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,Problem here. We have building management systems (temparature guages etc) with devices on one subnet and I suspect they are not connecting to their server correctly.I think they use broadcast and unfortunately the server is on another subne...
Hi Folks,I have a wave2 controller. I have a guest wifi that is currently using the management interface. I want to change the interface to use the correct one I have created for the guest wifi however every time I do this I get the below error.The f...
Hi,I am trying to setup a guest wifi network using an external provider for the guest wifi.I have fully followed their instructions but I think there may be a limit in the CISCO WLC 9800 ver 17.12.6aThe problem is that I am not seeing the SSID being ...
OK folks,About to throw a 9500 out the window.I attempted to build a virtual stack, configure single port for stack and single port for DAD, switch one works fine, switch 2 now fails to boot.Constant waiting for switch one to talk to it. So I decided...
We have AIR-CTVM-K9 controllers and buying new APs 9120s. We are on one of the latest version of code 8.10.185.0With the new APs going in I want to use their full capabilities. ie wifi6/6e but cant find configuration for this. Maybe I just need to lo...
Hi Aleabrahao,I think what you mentioned above is the type of answer I was hoping for. That the interface is irrelevant as yes we are using flexconnect.thanks,Chris.
Hi Mark,PID: AIR-CTVM-K9,Software is 8.10.185.0However I think I see what is wrong. If using an ip address in there (currently blank). Can I use an IP within the scope of the clients for that WLAN? In theory I suppose the IP wouldnt be used for anyth...
