Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So at the moment I have a trial with meraki for both MV32 and MV72. This to try the new sense license and integration to V-app.ioBut it seems that both cameras behave exactly the same:The connect just fine and show up in the dashboard, then after a f...
So opposed to the other posts on this my problem is the oposite. The MX makes it to simple to get an IP.at the branch location there are two Vlans (Internal and Secure), when a client that is connected to the Secure Vlan it contacts the domain contro...
Well it has been connected for since 02. feb. via ethernet, it seems that they recieve an IP from wireless and then change to another IP, which is the same every time.I\m using wired connection.
but then again, I see you have mr´s so just set up an employee ssid and tunnel that into another vlan if you ha e kt and then you. an granulate acces in the same way for this if needed , also routing to shared and employee print will be easier if nee...
it depends, if you have a large number of users that should not be in this policy the answer is yes. if the number is low, whitelist the clients mac adress.
If we assume that the clients we want to block, shape and or control are all wireless clients would it not be possible to assign ONE group policy by device type(all devices) at the SSID level and then again assign a scheduled policy on the vlan at th...
The way to do this would be to go out to your edge MX´s and configure them as spokes, when you have selected spoke you scroll down the same page to Org.wide setting where you will find the NON-Meraki VPN peer. Here you can add the VPN hubs or concent...