Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI have an 878 SDSL router that is connected to a firewall.Here are the details of the setup (addresses have been changed):The router address is 192.168.1.1 and the firewall address is 192.168.1.3. The public address set on the Dialer interface ...
Hello!I have a SDSL 878 router with a single IP address on the Dialer interface. I also have a /29 subnet of public addresses routed to this interface. This router is also providing the NAT between the private and public.Requirement is VLAN 1 is to...
HelloI am currently trying to Lab a solution using Jumbo Packets.I have a Catalyst 3750 connected to a Catalyst 3560. They are directly connected to each others Gigabit ports and are access ports in the same VLAN.Both ports are up and can ping each ...
HelloI have an issue:A remote site SRST is registered to CCM but the phones in that remote site stay unregistered in CCM. Everything is pingable end to end but the phones are in fallback mode with the CCM as standby?Any ideas would be appreciated, l...
HelloThank you very much for your assistance, however, your suggestion in this instance did not work. I received the following error:Router(config)#ip nat pool vlan1pool 1.1.1.1 1.1.1.1 netmask 255.255.255.255%Pool vlan1pool mask 255.255.255.255 too...
Hithank you very much for your reply.In actual fact there are no devices plugged into the switches at present. the ping tests I have been carrying out are extended pings from switch to switch on the console.RegardsRonnie
HelloThanks for your reply, here's some more info:1. There is no triggered event as such since this is a new install. We have phones here locally that register with CCM correctly and a local SRST.2. The Connection Monitor Duration field is blank i...
