Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, Bit of an odd one. I've got a /30 network I've configured over a transit tail circuit between our L3 switch and a network providers equipment, which requires media conversion from 1G fibre to 10MB copper. As part of this I've also configure...
Hi, I've got a 3560 running BGP and OSPF, and want to prefer the OSPF routes over the BGP ones for particular networks. As such, I've got a config as below:- router bgp xxxxx no synchronization bgp log-neighbor-changes bgp scan-time 15 network 17...
Hi there, I have the following scenario:- Net A - 172.20.82.0/24 (under my control) network Net B - Public (out of my control) network I have a bunch of servers on the Net A (172.20.82.0/24) network I'd like to PAT behind a Public IP before transmiss...
Hi,I work for a financial services company, and presently we're developing software for use in a trading environment that has a bandwidth limitation of 300kbps. As such our developers are looking at every way in which we can compress the data stream,...
...so it seems like I've got a definite bug in the toolkit that describes this issue - please check https://www.cisco.com/cisco/psn/bssprt/bss?searchType=bugIdfilterData&bugId=CSCdz77047&filterData=EMPTY&QueryString=backdoor%3Fst=kw&highLight=true&se...
Hi John,To get around this, you could create a loopback with this secondary interface address on it and change the network type to point-to-point to keep it from advertising a stub network.I am afraid this will cause the device to complain about IP...
Hi John, Thanks for the pointer, however I'm not looking to try and form an OSPF adjacency over that interface - I'm just trying to advertise the /30 network located on it. As seen in the config, I only use VLAN 200 to form my OSPF adjacency with a n...
Hi - output sent again via PM, and the remote end has definitely got the exact same configuration. Their encryption domain is only configured as my PAT address, and I've verified P1 and P2 settings with them end to end.
