Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Might as well start off the way I do in real life.I work at a generalist IT company in Missouri, in the VAR/MSP chunk. We have been Cisco/Meraki partners for a while, and we focus heavily on Meraki for our MSP clients. I was ready to be a CLI jockey ...
I recently upgraded an MX60 from 13.33 to 14.40. After the upgrade, their WAN link to their secondary ISP (Suddenlink) cannot maintain its static IP. It keeps reverting to pulling DHCP from that ISP in panic mode.The primary WAN link is fine. I've up...
Situation:Third party site-to-site tunnel drops with no warning every few weeks. The local and remote ends spend a few hours timing out on p1 due to no valid IKEv1 proposals. 4-5 hours later, the problem tunnel is up again and works for several weeks...
I have a site to site tunnel between an ASA5525 and an MX65. I control both ends.Tunnel had been running successfully for several months, so far as my team was aware. Recently, it's begun failing at random then recovering after 5-20 minutes without u...
@GreenMan wrote:Do you have a specific reason for running 15 (beta) firmware? Unless you're needing something specific that's only in the beta firmware, running with Stable or Stable RC will likely be more reliable. If there is a particular featu...
@johanoosterwaal wrote:Yes you can As i have done this many timeIn that case, are you sure your JSON is well-formed? Also, are VLANs enabled on your network? I feel like I ran into mystery failures on non-templated MX networks, and the ultimate prob...
@Edgar-VO wrote:I am pretty sure you cannot change the IP addresses when a site is bound to a template....There for you need to unbind, but then you loose a lot of details of the site,...Also wondering why you make your own definitions within python,...
