Hello alli am running into an issue where even though i'm able to successfully leak routes from a VRF to the global routing table and vice versa, devices inside the VRF (4.149.253.0/24) and devices from the global routing table (13.38.0.0/28) are sti...
Hello All,I have a DMVPN phase 3 setup between a hub router and two spoke routers in a lab enviornment. below is my configrationHUB SPOKE1 SPOKE 2 tunnels come up on the hub just fine via the above configs as seen belowat this point that's when thing...
yes i generated a default on core4s global table and leaked it into the VRF for access 4 to learn it .... but i got my issue resolved. I realized that i cant leak only default routes into a VRF i have to leak all the specific prefixes in order to get...
thank you for this!i took your suggestion and leaked 13.38.0.0/28 into the VRF and i now have reachability. However, is it possible to leak a default into the vrf that way i dont have to always leak every prefix from the global table in order to reac...
got it.So i did your suggestion and tried redistributing OSPF into BGP on the leak router (core4) but pings still fail between VRF and global. I also redistributed BGP into OSPF via mutual redistribution just to make sure.
CORE4 CONFIG TOWARDS CORE3interface GigabitEthernet1ip address 3.20.34.4 255.255.255.248ip ospf network point-to-pointipv6 ospf 300 area 0end!router ospf 300router-id 255.255.255.4network 0.0.0.0 255.255.255.255 area 0!Neighbor ID Pri State Dead Time...
