Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am backing out of a multipod config to recreate it again in my lab. I am to the point where I am trying to delete Pod2 and when I do I get this message: Can't remove TepPool 10.112.0.0/16 - NodeId 4151 is using IpAddress from this pool.Please chec...
I am running ACI 4.0.1(h) with vCenter 6.7 and have installed AVE 2.0.1a-r2. I have my VMM configure and AVE installed on vCenter which looks like it is up and running. I have communications with EPs as I would expect.
I am learning about Opflex an...
I have my L3OUT to my EIGRP router and my EPG subnets on the that router are showing up as external routes. I thought they would be listed as internal since they are part of the same network. Where do I change the setting in ACI to make sure the EP...
I have same output and I believe is it because of how the 9500s redundant supervisor as "warm" and really not hot. If you lose the active sup, the whole chassis comes up on on the warm supervisor. Active sup console: S201# show redundancy statusRedun...
https://developer.cisco.com/site/apic-mim-ref-api/?version=4.1(1) I use this site to help explain the mysterious abbreviations and help give a definition.
Thanks for the link. I had seen this doc. My issue was first understanding Opflex and there was a lack of documentation from Cisco about its own technology. What ended up being the issue was I was in a lab and my port channel was only one connectio...
