Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,
In a scenario with two different switching domains and I need to connected a UCS to both of them, normally I would use vlan-manager to trunk only specific vlans to each uplink.... Nevertheless I have the following questions:
1. what h...
Hello All,
After upgrading the CIMC using Host Upgrade Utility from 2.0(3) to to 2.0(13n) ... using "Upgrade All" option
After upgrade when Server boots to APIC/ACI software 2.2(1n) it fails with the following message !!!!
"No key available wit...
Hi,
Is there any rule on where are the logs for a Service-Graph placed ?
I have actually found where in the filesystem the logs are "/data/devicescript/CISCO.ASA.1.2/logs/*"
In a 3 APIC cluster what APIC is chosen ? Is there any rule ..... All I se...
I have the following scenario (the drag is attached):
1. iosv-1 is configured has DHCP Server2. iosv-2 is configured has relay agent for VRF A3. G0/1 and G0/2 are on the same VRF4. from iosv-2 I can ping iosv-1 usgin G0/2 as source5. iosv-3 works as ...
Hi,
I want to upgrade the APIC from 1.2(3h) to 1.3(2) and looking at upgrade procedure and recommended paths at:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/apic_upgrade_downgrade/b_APIC_Software_Upgrade_Downgrade_Guid...
Hello Aru, Sorry to bring this issue back Is this issue already solved ?If I use the "C9500-NM-8X" module, can I use this ports to build the SVL ? Thanks,Regards,BrunoBruno
