Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have a SG300-28P already up and running. I would like to access the Web management interface. I know that I need to activate it in CLI configure mode with: IP http server, in order to enable it and to configure the access to it. The default IP ...
Hi, I need some help here about a SX80. I have a camera connect to the SX80 by HD-SDI which is convert in hdmi to the codec. Since it is HD-SDI the EDID exchange can't happen. I need to control the camera by the control port by the codec. Is there a ...
Thank you for the answer.
Is it for any cameras, because I might have forget to say that the camera isn't a Cisco one, it is a Sony. I'll try to set the ID like you described earlier. Thank you.
