Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am having some issues with some citrix sessions over our MPLS network, my AT&T rep says the following:
"All the sites have Cos profiles. You need to tag the traffic and the network will see the markings and support them. Just like the voice,...
Guys,
I am trying to get my Anyconnect client 192.168.17.0 /24 to get to 10.45.2.4 (outside), and use the following network ip 10.120.253/24. But I am getting the below error message when I run a packet tracer. What does it mean that there is no ma...
Hey Guys,
I am thinking about gettng EIGRP, I am starting to get a lot of static routes, but I have about 10 managed MPLS sites, and about 4 VPN sites.
2 3750X in data center acting as cores2 ASA 5510 (8.2.5) active/standby
The core switches has the ...
Guys,
Hello I have a quick question, I have a 5506 that I am going to create a site to site VPN with, but I have a Meraki access point, that needs external access ony. My ISP gave me 5 public IPs, I was wondering how would I be able to use it, would...
Hello I am new to this, but I have a Cisco 2801 router, with a VIC2 -2FXS, is there any way to run a series of command to test to see if it has gone bad, and the samething for a serial interface?I am not sure how much more info you need, but please l...
Thanks, I have another question, my HQ want me to route my 10.x.x.x network to there ASA, but my VPN sites did not like that, would the alternative be to create a static route for my VPN sites to get routed to the outside interface automatically, ins...
