Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anyone having this problem? It happens every now and then when accessing the management page. The master AP is in the same room as the computer connected to it through WiFi and accessing the page.
Hello,I have a brand new AIR-AP1852E-E-K9 in CAPWAP mode, running 8.5.151.0, installed about 3 months ago, powering it using POE from a SG350-28P switch, the cable used is a 10m CAT6A. Suddenly I noticed that the AP was not powered anymore, checked t...
Hi,So I have a brand new (bought about 2-3 months ago) ISR4331-SEC/K9 running 15.something.something and I have just started booting it. I would like to enable the WebUI which I hope is similar to an SG350 WebUI where I can actually configure everyth...
Well the whole rack where the switch is installed is behind an Eaton rack UPS and there is 2 stage surge protection on the mains. If nobody else comes up with a clue in a couple of days I'll open a case.ThanksOscar
Currently not near the router, and not very good at the whole CLI thing.If HTTP is not configured, should I use the guide from HTTP Services Configuration Guide - Configuring the HTTP/HTTPS Client or... I actually used this guide before posting the ...
