Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Was going to ask this in the wireless forum but I'm assuming this is more of a routing / switching question.
I have an Aironet 1830 standalone Access Point
I've gone through the wizard and configured 2 SSID networks each in their own VLAN.
The guest...
I have to remote LAN's that I'm trying to connect.
At the end of one I have an RV082 small business router and at the other one, I've got an RV180 small business router.
I've made sure that the encryption and authentication match with what I've got ...
I'm trying to setup some static NATs for port 80 and 25 but for some reason it isn't working. When I try to hit my internal webserver from the outside address, it is just timing out. I've also tried various port checkers and they all state that port ...
I'm having a hard time doing some simple port forwarding for port 80 and 25. I've tried using both the public IP address and the interface. I've tried with and without an ACL. My config is below. Please tell me I'm missing something obvious here.
Fr...
The client is connected to the AP
The client gets an IP address from the router of 192.168.80.2
from the AP I can ping 192.168.80.1
The port on the switch that the AP is connected to is setup as a trunk with dot1q encapsulation and is set to allow VL...
I can ping 192.168.80.1 from the router
From the switch ping 192.168.80.1 source vlan30 is also successful.
Its not just ICMP, I've also tried telnet and I tried to do a trace route from the client to 192.168.80.1 without success. Its almost as if t...
