Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Steve,If they're back-to-back then you'll need a crossover cable. The cable that Cisco ships assumes that you're connecting the card to a DMARC which in this case you are not so you'll need a crossover. Pin 1 to Pin 4, Pin 2 to Pin 5 will mak...
Hello Steve,You'll also need a crossover cable. If the CSU/DSU card is set for T1 then you'll need a T1 crossover (1 to 4, 2 to 5). If the CSU/DSU is using something similar to a 56k then you should be able to use a Cisco Console cable with RJ45 on...
On the Dynamic interface that you assign to the WLAN you need to make sure you have the DHCP Server IP address as the MGMT interface of the controller. Clients that associate to that SSID will then get an IP address that is in the same network as th...
