Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is the NDO API backward compatible?I have two Nexus Dashboard deployments for different sites:Nexus Dashboard 3.2.1e (newer)Nexus Dashboard 2.1.2d (older)The following API works on the newer version but does not work on 2.1.2d:GET /mso/api/v1/nodesIs...
I'm migrating from MSO to NDO and have a few APIs that we use to monitor and configure things in MSO.Will those APIs continue to work after migrating to NDO, or do MSO and NDO have completely different APIs?
Hi Team,Good day!I plan to use 2 vAPIC in one site and 1 vAPIC in second site on 6.x version. As per this link, vAPIC's are supported in cluster without the need of physical apic. https://www.cisco.com/c/en/us/td/docs/dcn/aci/apic/kb/virtual-apic/dep...
Hi Team, I have a below setup in nexus where PE devices does not seem to forward CE routes. >> CE1 --- PE1 --- P --- PE2 --- CE2>> All of them are in same ASN. PE1 and PE2 receives the CE1 and CE2 routes respectively but then PE1 and PE2 does not see...
Hi Team,Need help on bgp nexthop feature.I am trying to use bgp nexthop in ASR as well in nexus 9000 but it is not working. ASR -router bgp <>bgp nexthop route-map <> Nexus -router bgp <>address-family ipv4 unicastnexthop route-map <> Can someone ple...
Hi Daniel,Thank you for the reply. It is msite setup only and I need to test a few things in lab. So, i am planning to use one vAPIC per site to complete my testing. I believe it will work. Regards,
Hi @Mark Elsen Device A (12.1.1.1)——(12.1.1.2) Device B (23.1.1.2)——(23.1.1.3) Device C Assume that I have 3 devices connected as shown along with the ip addresses. Device A is advertising a prefix 10.1.1.0/24Device C is advertising a prefix 30.1.1...
Hi @paul driver @MHM Cisco World Thank you for helping and providing valuable commands to troubleshoot the issue. I found that 'show run router' showing correct router-id configured on ASA-2 but 'sh bgp ipv6 unicast summary' shows a different router-...
