Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We currently have a mix of Cisco switches from 2960s, 2960X and now the 9200L. However we are having issues with our Paxton POE door controllers. The 2960s work with all of our Paxton ControllersThe 2960X up to hardware version 4 work with the Pa...
We have gone with..a) all new Net2 Controllers we purchase make sure they come with a power supplyb) We install a Netgear Unmanaged POE switch into the cabinets where the controllers go to and connect that back to the Cisco Switchc) Use Cisco Wireles...
The last switch we had working was a 2960X Hardware version 4 with any firmware. After that We've not been able to get any Net2 controller to be powered.
Paxton admitted to me that it was the Paxton Net2 POE Controller that wasn't fully POE compliant, other devices such as handsets and intercoms seem to be fine.We've given up on finding a solution and now use Netgear POE switches where we have to and ...
Its actually an issue with the Paxton controllers.. the older Net2 system kit isn't actually fully compliant with POE standards. We've had to put a single Netgear POE switch in each cabinet to power them.
