Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are upgrading our ISP link to a VRRP connection and in doing so they needed two of our public IP addresses. Due to this change they have provided two public subnets that they are providing via one handoff. My question is how do I set this up on ...
How would I accomplish the below config on a pre 8.2 ASA 5505?
object network obj-192.168.3.5
host 192.168.3.5
exit
object service obj-4370
service udp source eq 4370
exit
nat (insisde,outside) 1 source static obj-192.168.3.5 interface service obj-4...
I have a question regarding telling a static route to go over a VPN tunnel between two ASA's. I have a client who uses a public IP address range as their internal LAN for one of their sites. This site is connected via a VPN tunnel back to their mai...
A little insight into the company first I guess. I have a client who has approximately 40 locations. Most of the sites use site-to-site VPN tunnels for communication purposes. 2 sites have point to point links with metro e to the corporate locatio...
Thanks for the confirmation Jon. After posting I reached out to the ISP to check with them and they are indeed routing the new subnet to the existing one. That being said I don't even have to add it as a sub interface correct? Since they are handl...
Pablo,
Thanks for the quick follow up. I have a question regarding your route, specifically the next hop. The default gateway for these servers is the inside IP of the ASA at site B. That being said would I then set the static route on site B to ...
The CUCM is located in a different building than the data center. They are separated by about 120 miles. Would you have any other ideas? I appreciate the advice.
