Hello All,
I am assisting my local charity organization with their network. My network skills are basic, so I need assistance with configuring a Cisco c2960 series switch for InterVLAN.
Requirements: Local Broadband Router LAN IP: 10.0.0.1/24
...
Hi Richard,
I just am able to get over to their office.
Switch#Switch#sh ip arpProtocol Address Age (min) Hardware Addr Type InterfaceInternet 10.0.0.1 0 6aee.96c7.fae5 ARPA Vlan1Internet 10.0.0.169 ...
Hello Ganesh,
I was not aware of creating this template. Would this create an issue now if I created the template after the fact? Should I erase the configuration and start over again, creating the SDM template first?
Thanks!
Hi Alexey,
Switch#sh int vlan 1Vlan1 is up, line protocol is up Hardware is EtherSVI, address is 3c0e.23eb.c440 (bia 3c0e.23eb.c440) Internet address is 10.0.0.250/24 MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec, reliability 255/255, txlo...
Hi Alexey,
I did receive 10.0.20.3 on my test laptop and was able to ping all of the VLAN Gateways (10.0.10.1, 10.0.20.1 and 10.0.21.1).
From 10.0.20.3, I was not able to ping 10.0.0.1 (or past it). When I ran a tracert, the packet died at 10.0.2...
Hi Alexey,
Thank you for taking time to assist me!
This is from my notes. I am not onsite daily to be able to run show version.
The model is a ws-c2960x-24ps-l and the
iOS version is c2960x-universalk9-m, ver. 15.0(2) ex4-fc1
Thank you again for t...