Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Is it possible to configure a Cat 9300 running 16.9.1 to query the local database for RESTCONF queries bypassing the AAA TACACS config?
I have HTTPS is enabled and I have tried the following:
ip http authentication local
as well as:
aaa authentica...
Hi
I have a 5585X with 2 WAN interfaces.
One is the OUTSIDE interface which the default route points to.
The other is a VPN interface which I would like to use for Anyconnect VPN sessions.
I have configured PBR to set the next-hop of traffic sourced ...
Hi
Is the following possible and how can I achieve it? (I'm sure it is)
I want to set up a one to one NAT only for 1 external IP.
So if my router had the following:
Inside IP: 10.0.0.1Outside IP: 12.12.12.12
Inside server: 10.0.0.10External client: 1...
Hi
I have a C819G-4G router which works fine for a few hours before the cellular interface does down and up again, after which no external traffic is routed. If you log onto the router and manually shut/no shut the interface it starts working agai...
Thanks for the reply.
The external client IP address isn't part of my external address pool so surely this would not work? I just labbed it and it wasn't successful.
I am familiar with static NAT, but I am not sure if the solution lies in a NAT/route...
Hi
Thanks for the reply.
I have loaded the recommened IOS version.
I Just use the Cellular interface. I have tired the dialer idle-timeout setting but the outside connection still drops (even though the status and protocol for the cellular intefrace ...
