Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm attempting to create a Hub and Spoke VPN configuration with several ASA's. I'm able to successfully get the hub talking to both spokes and the spoke talking to each other. This configuration is for a network whether the hub is a service provider ...
Customer has a 2811 router with an NM-CUE module. Service-Module Service-Engine 1/0 status show the following: Service Module is Cisco Service-Engine1/0Service Module supports session via TTY line 66Service Module is waiting for registration messageS...
The network is setup as described below:Site 1:DSL ModemPIX 506 (Handles PPPoE Authentication)Cisco 2620 with T1 to site 2Site2:Cisco Cable ModemPIX 506 (Gets DHCP address through cable modem)Cisco 2620 with T1 to site 1I have the network setup route...
Thanks. That's what I thought. I'm trying to configure this a my lab and having trouble though. Here's what I am trying to accomplish: HUB should communication with spoke1 and spoke2 via ipsec vpn using their own internal addresses HUB: 192.100.10.0/...
Thanks. I actually got Cisco TAC involved and they recommended the same thing. Unity Express is back up and working with no lost data. WoooHooo! Thanks again to all that helped.
The service module seems to respond to the shutdown command and now shows status of "is Shutdown". Is there anything to be gained by reseating the module?
