Hi,Want to set up VLANs on a RV340.Question:Is there a way to set up the 192.168.1.x subnet with a VLAN other than the default VLAN 1? Like, VLAN 10?What is the procedure for doing this?Thanks.
Hi,I have a ASA 5516-x running FTD 6.4.0.6.I'm using https://www.cisco.com/c/en/us/support/docs/network-management/remote-access/212424-anyconnect-remote-access-vpn-configurati.html as a guide to setting up a client to site VPN connection.In section ...
Hi,
So I was upgrading an ASA 5506-x from 9.9 to 9.10 using the "Tools / Check for ASA/ASDM updates..." function of the ASDM launcher.
It found the 9.10.1 update, but then a message box popped up:
"Module Firepower is not supported on this plat...
Hi,
Newbie question.
I have a 2960x with 3 VLANS (native VLAN is 1), already configured and working, in the sense that a PC on VLAN 1 cannot see a PC on VLAN 2 or 3. That is all I need. I do not need to do inter-VLAN routing. Nor do I want to use...
Hi,
Newbie question:
I have a 2960x with 3 VLANs, 1 (native), 2 & 3.
Port 24 is set up as a trunk so that it can carry traffic from all 3 VLANs. It will be connected to a router, to provide Internet access. We do not need to route anything betw...
Hi Martin,I am well aware of that page, thank you.But it does not answer my question.My question was, Is there a way to set up the 192.168.1.x subnet with a VLAN other than the default VLAN 1? Like, VLAN 10?I cannot change the VLAN ID of VLAN 1, it w...
Same problem here, RV340, latest firmware, 1.0.03.15.I'm using DynDNS. The DynDNS update log says it's been receiving updates, every 30 minutes, as configured.But the Status column on the Dynamic DNS page says "disabled", even though I edited and sav...
Thanks for the update.
Does the firmware also address this issue?
https://community.cisco.com/t5/small-business-routers/rv340-not-able-to-connect-through-pptp-or-l2tp-known-bug-due-to/td-p/3202073
That post was for a non VLAN aware router. This post is for the ASA 5506, which is VLAN aware. So I posted it here.
No such thing as a simple answer in Cisco land, is there? Why'd they even bother with a GUI on the 5506 if you can't do anything wit...