I´m configuring for the first time a 2911 router and I need to connect with a serial RJ-45 cable to router console I´m using the suggested configuration settings Speed 9600 Data bits 8 Stop bits 1 Parity none Flow control none However I have no success, the connection opens but does nothing, press enter and nothing happens. I´ve tried with windows hyper terminal and putty. This is the same cable I use to connect to other router without problems, Am I missing any step? Thanks! ... View more

Me encuentro configurando por primera vez un router CIsco 2911 (recien sacado de la caja), y necesito conectarme por consola con un cable RJ-45 - DB9. Estoy utilizando las configuraciones de conexión sugeridas Speed 9600 Data bits 8 Stop bits 1 Parity none Flow control none sin embargo no tengo éxito, se abre la conexión pero queda en blanco, presiono Enter y nada. He intentado con el hyper terminal de windows y con el putty. Este mismo cable lo uso para conectarme a otro router sin problemas.. Alguna sugerecia? Gracias! ... View more

I need to configure my asa as follows: Two active ISP´s, one(ISP1) for outbound traffic (normal internet traffic) and the other one for inbound traffic(ISP2), http to a web server in the inside network. I have two default routes, one pointing to ISP 1 with metric 1 and the other to ISP2 with metric 2. I perform dynamic nat to ISP1 interface with hosts in the inside network and static nat to ISP2 interface with web server. Everything works fine with ISP1 but I cannot access my web server from outside..any suggestions? Thanks in advance, Laura ... View more