Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am trying to upgrade the IOS on one of our 6509 switches, with MSFC and Sup2 cards.I downloaded the image onto a new formatted 64Mb flash card. Despite having half Gb of DRAM and the 64Mb card, on rebooting the 6509 the following error was repor...
HiWe're about to implement a new WAN running OSPF which we intend to run alongside our current EIGRP network using route redistribution.My question is - If a route within the OSPF network goes down, will the L3 switches in the EIGRP network learn abo...
HiWe have been experiencing some problems on a 6509 switch which routes primarily using Policy Based Routing. PBR has been configured to fast-switch (by issuing ip route-cache policy) in all VLANs.The problem is that users connected to certain VLANs ...
HiSeveral servers on our main 6509 Server access layer switch have started experiencing problems this morning. These servers have 'Incomplete' in place of a mac address entry in the ARP table. I'm guessing this is looing like a hardware fault with on...
HiOne of our PC support engineers has connected a PC to a 2950 switchport (via infrastructure copper cabling). A 'sh int f0/9' shows the link and line protocol as being 'UP'. The corresponding switch green light is on. However!The PC is showing as no...
Jon,Thanks for your reply.Not having done any route-redistributing before I was unsure how one protocol would inform another of a downed route. I suppose I was thinking of the route-redistribution process as a 'one-off'. I.e EIGRP learns about all th...
Thanks for the replies guys - v useful.What does Cisco recommend in terms of firewall monitoring? As these ASAs will be replacing a 3rd party managed service they need to be able to generate alerts based on unusal behaviours, DoS attacks etc. Which s...
Thanks - I had assumed the threshold part of the queue mapping was actually applied globally and referred to queing priorities. This has got me thinking!if you don't mind can I refer you to the QoS config on one of our 2950 switches:wrr-queue bandwid...
