Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to upgrade C8300-1N1S-6T from Cisco IOS XE Software, Version 17.12.03 to recommended Cisco IOS XE Software, Version 17.12.06
I was able to submit "install add file ....." and "install activate" commands, after the router reloaded it was no lon...
Hi Mark,
Thnx for your reply, actually my current version Version 17.12.03 or the target version 17.12.06 are not listed as affected releases on either
CSCwp83205 or CSCwd48802
I opened this thread referring to the pattern of
CSCwp83205
Br
Hi Marcelo,
Thanks for your reply.
1. We already have taken care of the certificates on the new node that will be registered.
2. New node is the same version/patch as existing PPAN, so no surprises there.
3. We don't intend to keep the de-registe...
Hi Rob,
Thanks in advance for your assistance.
Since this thread is somehow related to the situation I'm facing, kindly clarify if the following is correct.
In a distributed deployment, in case of hardware refresh:
Replacing the nodes with from 3...
Great job by the way.
I'm in the same situation as "Scenario 1" due to hardware refresh.
Regarding TACACS+ network device administration:
a. If there are 2 TACACS+ servers configured on IOS devices (router, switch etc...).
b. Each TACACS+ server ...
In a distributed deployment, in case of hardware refresh:
Replacing the nodes with from 3655 (old) to 3595 (new) with same IP address and hostnames (FQDNs)
1. Configure first the 3595s in an offline environment with the same IP addresses as the nodes...
